The first pictures are the pipe after the first group of finish sanding. This is done to get a better good idea of the grain type of direction before final finishing.


These final pictures are after final staining & finishing. I used a two tone finishing approach with this pipe. The first step is to use a black aniline dye to stain the pipe at 3 different stages. This process is very time consuming by requiring the base pipe to sanded at 220, 320, & 400 while receiving a coat of dye between each sanding. After the base staining, I was able to sand lightly at 400 then stain with cardinal red, then do the same process again in stages of sanding & staining at 500, 600, & 1500. A final coat of stain was applied and then the pipe was brushed with XXXXX steal wool. All the pipe needs now its a fresh coat of carnauba wax. As you can see the double staining process allows for the grain to standout quite nicely.




